Get started - Upload and inspect your part (CO-AM Base)

Learn how to upload your part and effectively inspect it for quality and accuracy in just a few simple steps.

View it in 3D and check manufacturing details.

Upload a part straight into CO-AM and open it in the 3D viewer to look at it from any angle, no desktop software needed. Beyond just viewing, you can run a wall thickness analysis to see whether the part is likely to print cleanly. You set a minimum and a maximum threshold, and the viewer flags the areas that fall outside them so you can spot thin walls and problem zones before anything goes to production. It gives sales, engineers, and anyone else a shared, quick read on printability without going back and forth over email. If a part does need fixing, you can take it into Magics from here to make the changes.

 

Was this article helpful?

Can’t find what you’re looking for?

Our customer service team is happy to help!